• Clear satin finish

• Quick drying

• Water based

• Non-yellowing

• Low odour

• Heat resistant

• Stain resistant

• Biocide free 

Titan Topcoat is a quick drying, low odour, non-yellowing clear satin finish. It is a multipurpose tough but flexible waterproof coating. It can be applied to most types of wood and sheet materials, such as plywood and MDF. In addition, it will bond to many other surfaces including masonry, concrete, terracotta, metal and laminates.

It is perfect for surfaces that need to be waterproofed and hygienic such as bathroom and kitchen floors, cafes and bars, laminate floors and outdoor furniture.

Titan Topcoat can be diluted with cold water for a variety of purposes including spray application or to create a thinner basecoat sealer before applying further coats. Further dilution will produce an excellent primer for new plasterwork prior to painting. If you are applying this coating over Littlefair's Water Based Wood Dye. It should be possible to both dye the wood and apply two full coats to your project within the day, after an early start.

Preparation

Careful, thorough preparation will result in a far superior finish, especially when applied over our Water Based Wood Dye.

(Please refer to the instructions on the dye). 

If you are dying the wood first, the final appearance will be a combination of the wood’s natural colour, the dye and the topcoat. It is always a good idea to prepare a test piece in exactly the same manner as your project. 

Application

Titan Topcoat can be applied with a good quality brush, roller or applicator pad. Aim to work quickly and confidently and try to avoid overlapping. 

When applying to larger surfaces such as doors, floors and table tops it helps to dilute the first coat with about 20% cold water and brush out a thin film as a basecoat. The first full coat can now be applied both across and along the grain, but aim to make the final brush stroke along the grain to achieve an even coverage. 

Completion

The first full coat can be lightly sanded with 240 grit abrasive if you feel it necessary - or, you may prefer to build up the thickness of the topcoat and only sand it lightly before the final coat. To clean your brushes and equipment - simply rinse thoroughly with cold water. 

It’s important to note that the final appearance on wood will be a combination of the wood’s natural colour, the effect of the dye (if used) and Titan Topcoat. With this in mind - always produce a test piece so you can properly judge the result. 

Drying Time

Touch dry in approximately 30 minutes and can be recoated after 2-3 hours in suitable conditions. 

Please note: this is an approximate drying time. There could be a number of factors that may effect this. 

Coverage

Approx. coverage of 12m² per litre, for one liberal coat.

This is not recommended for use with our oils.